MAXI-CURE extra thick CA is the best CA for most plastics, including Ges Lexan MAXI-CURE is the best choice for plastic model assembly. When used wi...

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than...

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than...

INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during pol...

Maxi-Cure extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE is the best choice for plastic model assembly. When used w...

Super-Fix™ is two-part adhesive system developed to fill gaps and voids. It is sandable and paintable and cures in 1 - 3 seconds. Super-Fix™ is grea...

UN-CURE deboned will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE will dissolve the C...

QUIK-CURE 5 min. epoxy cures to a slightly flexible consistency. This lack of brittleness allows it to form a lasting bond in areas subjected to hig...

QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency. This lack of brittleness allows it to form a lasting bond in areas subjected to hi...

MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed. It is more water resistant and can be used as a substitute for QU...

MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed. It is more water resistant and can be used as a substitute for QU...

SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of our epoxies. It is waterproof and more...